McAfee SECURE sites help keep you safe from identity theft, credit card fraud, spyware, spam, viruses and online scams Toll Free (866) 526-2873
sales@americanscreeningcorp.com
Phone (318) 798-3306 . Fax (318) 798-3386
PO & Money orders Accepted.
Click to verify BBB accreditation and to see a BBB report.

facebook twitter linkedin Googleplus Instagram
Home  >  Drug Tests- Lowest Price!  >  Alcohol Tests- Saliva  >  Q.E.D.®- Saliva Alcohol Test (ALL)
Q.E.D.®- Saliva Alcohol Test (ALL)
Q.E.D.®- Saliva Alcohol Test (ALL)
Choose Options
Price:
$236.25
Quantity:
Quantity:
More
Less
 
OR




Earn up to 236 Reward Points

Key Advantages
  • Quantitative results in 2-5 minutes
  • Reads like a thermometer
  • Long shelf life
  • Built-in quality control spot
  • CLIA waived, DOT Cleared
  • High correlation to blood analysis
  • Non-invasive
  • No instrumentation required
How it Works

1. Collecting saliva: Actively swab around the cheeks, gums, and under the tongue for 30-60 seconds until the cotton swab is thoroughly saturated.

2. Filling the capillary: Place the Q.E.D.® test on a flat surface. Gently twist the collector into the entry port. Apply gentle steady pressure until the pink fluid passes the QA Spot™ at the end of the device

3. Interpreting test results: Allow two (2) minutes for the Q.E.D.® A150 test to develop. The QA spot must be dark purple to indicate a valid test. If the same color forms a bar within the measurement scale, read the highest point. Ignore bubbles. Diagram of Enzyme Chemistry Used by the Q.E.D.® Test

• Meets 2006 U.S. Coast Guard Maritime Requirements
• Non Invasive, Quantitative Results in 2-4 Minutes
• Interpretation like Reading a Thermometer
• Long Shelf Life of 10-12 Months
• Individually Sealed in Foil Envelope with Cotton Swabs
• Built-in Quality Control and Calibration
• U.S. DOT Approved for Testing and Evidence
• High Correlation (r=.098) to Blood Analysis results
• No Special Equipment or Training Required

SKU QTY Price
31150B 30 $236.25
31150C 100 $787.50

 

TEST PROCEDURE:

The Q.E.D.® Saliva Alcohol Test is an easy to use diagnostic procedure with everything required contained in a sealed foil package. Total time required for the test is between 3 and 5 minutes. The three basic steps are as follows:

qed1 qed3 qed2

1. Using the cotton swab included, actively swab around the cheeks, gums, and tongue for 30-60 seconds or until the cotton swab is completely saturated with saliva.

2. Place the test device on a flat surface. Gently twist the swab with the collected saliva sample into the entry port and apply steady pressure to activate the capillary action until the pink fluid passes the QA Spot™ located at the top of the test device.

3. Read the test results. Allow the test device to develop for two minutes. A distinct purple bar will form within the marked scale region. The highest point of the purple bar represents the level of Alcohol expressed as either a percentage (.0x%) or milligrams (ml/dL) concentration.

Frequently Asked Questions:

How accurate is the QED® test?
The Q.E.D.® test can be used as an accurate screen in place of blood or breath tests. In clinical trials, saliva alcohol levels measured by the Q.E.D.® demonstrated high correlation to blood analyzed by gas chromatography (r=0.98).

What range of BAC will the Q.E.D.® test measure?
The Q.E.D.® test has a quantitative range of 0 - 145 mg/dL (0.0% - 0.145% BAC).

What is an advantage of using the Q.E.D.® instead of an electronic breath analyzer?
Unlike breath testers, you can make a permanent record of test results for a file by making a copy of the completed test on a copy machine.

What does a positive reading look like with the QED® test?
When a QED® test result is positive, a dark purple color bar forms within the measurement scale. This color is distinctly darker than the pink or orange color seen as the sample fills the device. The color bar on a positive test -- the same color seen in the QA Spot™ --
develops in 2 minutes for the A150 test, in 5 minutes for the A350.

How hard should I press down with the QED® applicator?
Gently apply slow and even pressure when placing the swab in the entry port. Too much pressure can jam the test. For best results, gently twist the collector into the entry port until the cotton touches the red filter pad and then begin pressing.

What does the Clinical Laboratory Improvement Act (CLIA) waiver mean for work
site testing?

Because work site testing is considered forensic testing, CLIA regulations do not apply. The waived status for the QED® Saliva Alcohol Test under CLIA '88 makes testing easier in hospitals, rehabilitation centers and treatment facilities where our test is used
as an in-vitro diagnostic tool.

Does the QED® test measure residual alcohol in the mouth or is it measuring the alcohol
within the entire body (blood stream)?

Beverage alcohol (ethyl alcohol) is absorbed directly and unchanged into a person's body and is evenly distributed throughout the blood stream and other bodily fluids, including saliva. The QED® test measures the amount of alcohol in bodily fluids, commonly called blood-alcohol concentration, or BAC. Residual alcohol in the mouth just after a person takes a drink is quickly absorbed, swallowed, or evaporated, and a person's mouth is "clear" of residuals 10 minutes after eating or drinking.

Will the QED® test react with ketone often found in the saliva of diabetic patients?
No. Unlike breath analyzers and other saliva tests, the QED® test is specific to ethyl alcohol and will not cross-react with acetone and ketone produced by diabetic patients.

Will the QED® device work if it is stored at temperatures outside the range on the packaging?
Storing and using QED® tests at room temperature (15-30ºC, 59-86ºF) insures optimal performance and a full shelf life. However, the QED® test will work fine if exposed to temperatures outside that range for limited periods. We tested the QED® device under a wide range of temperatures and storage conditions -- simulating the inside of a vehicle glove box on a hot summer day (about 120ºF) and the
lonely cold of North Dakota in January (about 0ºF). In all cases, the test performed as it should. Before using a QED® Saliva Alcohol Test exposed to extreme heat, allow the device to cool to room temperature; if the QED® device is exposed to extreme cold, put it into a pocket to warm it up.

How can companies using the QED® test in very remote areas comply with the DOT's requirement that confirmation tests on positive screening tests must be conducted within 30 minutes?
The DOT will accept results of confirmation tests conducted more than 30 minutes after a positive screening test. Look to 49 CFR Part 40 section 40.65, paragraph (b). The DOT added a sentence which directs the Breath Alcohol Technician (BAT) to simply explain "why?" if a confirmation test is done more than 30 minutes after a screening test. This is not a fatal flaw.

Why should I buy the QED® Saliva Alcohol Test if I need an Evidential Breath Testing (EBT) to confirm positive test results?
The QED® test is much less expensive to operate than a breath test, unless you conduct a very high volume of tests in a central location. By and large, each test done on saliva instead of breath saves money. Plus, performing two independent tests is more legally defensible on the rare occasion an employee does test positive for alcohol.

Catalog# 31105

Qty: 10

Reimbursement: 82055QW ($14.93)

FDA Cleared & CLIA Waived

 

No additonal product FAQ's at this time

Customers who bought this product also bought: